The 21 Miller bone file is selected whenever a surgical site needs final smoothing of sharp or irregular bone margins after chisel work, extraction, or osteotomy, and the clinician wants a straight-cut pattern that only engages on the pull stroke. This single-direction action gives more tactile control over how much bone is removed per pass, which matters most near thin cortical plates or close to adjacent root surfaces where a two-direction cross-cut file could remove bone too aggressively.
Both working ends carry a straight-cut serration, meaning the file is drawn toward the clinician to shave bone rather than pushed or used bidirectionally. The 8.1 mm end is sized for broader ridge and alveolar crest smoothing, while the 4.8 mm end on the opposite tip is proportioned for narrower access such as interproximal septa or the margins of a small osseous defect, so one instrument covers both a wide and a narrow working field.
Clinically, the 21 Miller is most often reached for after chisel or osteotome work to remove residual sharp spicules and round off the ridge crest before flap closure, and it pairs naturally with the cross-cut 1X Miller-Colburn when a case calls for faster bulk smoothing followed by a more controlled finishing pass. Double-ended, medical-grade stainless steel, corrosion resistant, autoclavable.
Product Features
- 21 Miller Bone File 8.1 mm and 4.8 mm working ends smooth alveolar bone with a controlled, single-direction pull stroke
- Straight-cut serration engages only on the pull stroke, reducing the risk of over-removal near thin cortical margins
- Double-ended design pairs a broad 8.1 mm end for ridge surfaces with a narrower 4.8 mm end for interproximal access
- Suited as a finishing instrument after chisel or osteotome bone removal
- Same working-end geometry as the 1X Miller-Colburn, with straight-cut serration instead of cross-cut
- Rounds sharp bone spicules and margins prior to flap closure
- Medical-grade stainless steel, corrosion resistant, fully autoclavable
21 Miller vs 1X Miller-Colburn: The 21 Miller shares its working-end geometry with the 1X Miller-Colburn but carries a straight-cut serration instead of a cross-cut pattern, so it removes and smooths bone only on the pull stroke. Choose the 1X when two-direction cutting is needed to reduce chair time; choose the 21 when a single, more controlled pull-stroke pass is preferred near delicate margins.
Reviews
There are no reviews yet.